AP2 Ground Station System – Q & A

Q1：Unable to power on ?

(1) Check whether P2 PCU battery is well connected.
(2) Check whether AP2 flight control system and P2 PCU signal cable is well connected; also check whether AP2 flight control system is well connected to BEC unit.

Q2：Oscillation happened while lift-off the ground or in flight.

(1) Please check the main rotor and follow the instruction, ensure to tighten the screws back after straightening the main rotor. Make sure the main rotors stop rotation naturally on its own or it’ll effect the flight performance.
(2) Ensure to check and adjust the pitch of the blades and keep them rotate at the same path.

Q3：The cooling fan is not running.

Check whether the cooling fan is well connected with P2 PCU unit.

Q4：The cooling fan is on but the temperature is still high.

Check whether the temperature sensor is well connected with P2 PCU unit. If the temperature sensor loose or damaged, the system will show the highest temperature degree on the ground station.

Q5：While starting spraying, the pump is not working.

(1) Check whether pump ESC did emit sound while heli boot.If there is no sound, please check the connection between pump ESC and P2 PCU unit, ensure they are well connected.
(2) Check the AP2 settings in ground station system, the spray rate value should set over 50 so the pump will work accordingly, otherwise not.

Q6：While starting spraying, the pump works but unable to spray successfully.

(1) Inhalation of air causes the air pressure to exceed the pump pressure. Please remove the nozzle and release the air to balance the pressure in pump for next spray mission.
(2) Check and clean the dirty in spray pipe and nozzle to ensure running smoothly.

Q7：Unable to connect to the ground station.

(1) Check 5G WiFi connection to ensure video transmitter is connected to the tablet successfully.
(2) Check if ALIGN Agricaltural Helicopter boots correctly follow by the manual instruction?

Q8：In camera mode, there is no options for AP2 ground station setup ?

(1) The standard 1080 DV only works as video transmission, no need for setting adjustment.
(2) For 1080 DV, there is no options for set up in ground station.
(3) Upgrade with 4K DV, it allows for camera setting, such as lightness, saturation and contrast…etc.

Q9：There is no audio sound while operating ground station?

(1) Open the sound setting page and adjust the volume.
(2) Get into “Settings” in your tablet: Language & Input > Text-to-speech output > Select [Google Text-to-speech engine].
(3) After setting up completely, please check if the voice play is normal. Press the play or listen sample during for test. If the voice cannot be played, please install the voice data to the tablet.
Remark: The “System Settings” may be varied based on different tablet brands, so please refer to your tablet manual for further setup.